HOMCOM 824-038V80 Manuel D'instructions page 5

5. The plug must be removed from the electrical outlet when not in use and before
moving, installing, uninstalling and cleaning.
6. Do not add any chemical or metal ingredients into the water tank. These
materials are dangerous and may cause problems.
7. Be careful not to expose infant and elder directly to the air cooler for a long time.
8. This appliance should be used under the rated voltage and frequency as
indicated in rating label.
9. This appliance is not intended for use of persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning
use of the appliance.
10. Do not use your air cooler in or around water may cause electric shock and risk
of fire.
11. Do not pull while the power is on. Always ensure that the plug is fully inserted
into the electrical outlet before operating.
12. Do not attempt to disassemble, repair or modify this appliance for the warranty
will be void if repair is carried out by unauthorized person/services.
13. Do not leave your unit under direct sunlight for a long time.
14. Before using the evaporative air cooler, always ensure that it contains water.
Clean the tank with fresh tap water every two weeks.
Cleaning and Maintenance
Dusts may accumulate in the dust filter or cooling pad after some time and may
affect the cooler's function. Therefore it is recommended to clean your evaporative
cooler regularly. Below are written steps on how to clean this unit；
Turn off the air cooler and unplug the power cord before beginning to clean.
1. Dust Filter
To remove the dust filter, Use mild cleaning agent and soft brush in removing the
dust and dirt on the filter. When done, first attach the bottom part of filter then push
the upper part to secure it.
2. Cooling Pad
After removing the dust filter you can see the cooling pad. Press the lock in the
middle and gently pull out the pad. Use a clean cloth or soft brush to remove dust
and dirt from the pad. Rinse with clean water if needed and leave open air dry.
Never use any harmful chemical solution for may cause damage to the pad.
Your cooler takes water from narrow section of the tank and pumps it on the cooling
pad. The water flowing through the cooling pad goes down to the large section of the
tank. The cycle results to absorption of dust and dirt in the air which makes the air
safer and fresher to breathe. The filter that is located at the middle portion of the
tank cleanses the water that passes through it and shoul d be attached to its place
upon use of the unit.
5