Gazebo Penguin Yosemite Manuel D'instructions page 29

Before you assemble the Gazebo
• Please don't destroy boxes until completely assembled.
• Please verify the content of each box against the list of parts.
• It is important that this gazebo be anchored on a solid base with the provided screws.
Otherwise, please ensure that you use anchors sufficient for your surface.
• The gazebo should not be installed adjacent to trees or a sloped roof. Snow and ice may
slide onto the gazebo and cause it to collapse.
Tools Required (Not Provided)
• 6ft (1.8m) x2 Stepladder
• Robinson #2 Screwdriver
• Safety Gloves & Glasses
• Phillips #2 Screwdriver
• Ratchet SET
Step 1
A
1.Connect Corner Post Base Plate (B) to Corner Post (A) using Bolt (AA) and Steel washer (AA-1).
Repeat for all Corner Posts
and Base Plates. Repeat for opposite side. Tighten all Bolts. See Figure 1.
• Tarp or protective material for placing
• Tape Measure
• Leveling Shim
AA
AA-1
AA
Fig 1
parts on during assembly
A
AA-1
B
AA-1
Fig 1
29
AA