IGM FD300 Mode D'emploi page 4

FD300 & 600 DOVETAIL JIG
The FD300 & 600 Dovetail Jig is designed to rout ½" half blind dovetails using a dovetail router bit and a
template guide bushing. The following optional accessories can by used to rout other kinds of joints:
- 6,35mm (¼" ) half blind dovetails
- 8mm (5/16") box joints
- 12,7mm (½") box joints
- 12,7mm (½") through dovetails
- 19mm (¾") through dovetails
- 32mm dowels joints
Standard Equipment:
Joint size:
Max. stock width:
Stock thickness:
Template guide diameter:
Weight:
Max. dia. of router base:
ASSEMBLY
Illustration B1
Thread the screw # 15 into the body from the inside of the extrusion, using the hex key to tighten the screw.
Thread the aircraft-type hex nut #2 onto screw #15 from the front of the jig. Slip on washer #11 and screw on
the knob #12. Repeat this procedure on the other end of the jig.
Only for FD300
Attach the edge guides #3 with screws #10. As shown in illustration C1, these guides should be placed in
position "U1" on the top surface of the jig, and in position "F1" on the face of the jig.
( see illustration C1 )
Only for FD600
Illustration B2 - B3
Put sliding stop guides #.20 to the body between the spacers which are mounted in factory. Fit stop
U-bracket #17 with screw #18 and slightly tighten female knob #19. Fit edge stops #3 with screws #10 in
position U1 and F1 ( see illustration C2 ). Tighten the screws of the egde stops.
Attach the rubber feet #16 to the bottom of the jig.
Illustration B4
Attach brackets #13 to template #5 with the countersunk holes upward, using screws #14.
Illustration B5
Assemble the clamping bars #4, springs #9 and washers #8 as shown, and attach this assembly using the
knobs #7.
Only for FD600
FD600 middle clamp knobs male are provided when using workpiece less than 305mm. This ensures
workpiece is held securely. When using workpiece over 305mm wide the middle knobs must be removed.
FD300
half blind dovetail 12,7mm (½")
305mm (12")
12-25mm (7/16" to 1")
15,8mm (5/8")
6,9kg (15.2 pounds)
180mm (7-1/16")
- GB 2 -
FD300 & 600 Operating manual
FD600
610mm (24")
12-25mm (7/16" to 1")
15,8mm (5/8")
12,3kg (27 pounds)
180mm (7-1/16")