IGM FD300 Mode D'emploi page 11

Sliding stop bar right FD600
20
Sliding stop bar left FD600
21 Guide bush D15,8mm x 4mm
22 Screw M5 x 8
23 Hex key 2,5
24 Hex key 4 FD300
25 Hex key 5 FD600
Spanner 10 for FD300
68
Spanner 13 for FD600
61 Sliding stop spacer upper 2 x M4 FD600
62 Sliding stop spacer upper FD600
63 Sliding stop spacer 2 x M4 FD600
64 Shim 0,1mm (0,2mm) FD600
65 Screw M4 x 12 FD600
66 Screw M4 x 25 FD600
• Before changing router bit or making any kind of adjustment, always turn off and unplug your router.
• Use protective glasses during routing.
• Use hearing protectors.
• Always use a dust-protection mask or respirator.
• Use dust collection.
• Do not wear loose clothes. Make sure that your sleeves are either rolled up or fastened and that you are not
wearing a tie.
• Before starting your router remove all tools, nuts and other loose object from the work area.
• Avoid an inadvertent start of your router. Before you plug it in, verify the switch is in "off" position.
• Before you make any adjustments, wait till your router cutter completely stops.
_______________________________________________________________________
This document has been sent for your personal use only. All usage and reproduction is forbidden whithout written permission from IGM Bohemia Ltd.
SAFETY
w w w . i g m t o o l s . c o m
IGM Bohemia Ltd.
Hlavni 201 - CZ 25267 Tuchomerice - PRAHA-ZAPAD - Czech republic - E.U.
Tel. #420 220 950 910 - Fax #420 220 950 911 - export@igmtools.com
© 2005 IGM Bohemia Ltd.
- GB 9 -
FD300 & 600 Operating manual
1 FD6001-08A
1 FD6001-08B
1 FGB158-04
2 FS200143
1 F9900620
1 FS800005
1 FS800001
1 FS800008
1 FS800009
2 FD6001-16
2 FD6001-15
2 FD6001-18
8 FS101013
4 FS200133
4 FS200132