Publicité
Les langues disponibles
Les langues disponibles
Please read these assembly
instructions completely,
observe the instructions
and keep it in a safe place
for future reference.
Scope of delivery
1. Rafter bracket
2. 2x Hex nuts
3. 2x Flat washers
4. 2x Hexagon head bolt
M12*30
1.
80 mm
2.
3.
4.
Service
In case of service requests
or spare parts, please con-
tact your local HORNBACH
store or write an email to:
service@hornbach.com
50
|
ENGLISH
190 mm
100 mm
Symbols
Please read this user
manual carefully and
keep it for further ref-
erence.
Warning of accident
and injury to persons.
Intended Use
This product is designed exclusively for attaching awnings
to rafters.
Any other use or modification to the product is considered
as improper use and could cause considerable dangers.
Attaching to any other support like e.g. furniture can impair
the stability significantly. The product is designed for out-
door use. It is not intended for commercial use.
Mounting material
WARNING
To prevent risks during installation, the fastening
should be performed by a sufficiently qualified person.
•
Only use certified wall fasteners.
•
Never use a defective bracket.
•
All of the fastening scews provided have to be used.
Prior to the installation, check if the support material at
the installation site has sufficient load carrying capacity.
Depending on the support material at the installation site,
the correct fastening must be selected in order to ensure
a secure fixation. It is highly recommended to consult a
specialist in order to figure out which fastening is the ap-
propriate one.
WARNING
Consult a specialist, if there is any doubt on the load
carrying capacity of the installation site.
The max. admissible load for the rafter bracket is
40 kg!
ENGLISH
|
51
Publicité
