Publicité
Les langues disponibles
Les langues disponibles
•
Put the 6-way multiport valve to the "FILTRATION" position,
•
Restart the pump,
•
Close the 1/4 turn valve (F) on the waste line.
After back washing, the black hand on the pressure gauge should be realigned with the blue hand, that is
the pressure reading should return to the nominal pressure
In the event that the pressure indicated by the pressure gauge does not drop after back washing the filter
once (or even twice) contact your installer.
6.
WINTERIZING THE INSTALLATION
•
Backwash the filter,
•
Treat the pool water with winterizing products.
•
Run the pump with the mulitport valve set to "circulation" to homogenise the concentration of these
chemicals in the pool water.
•
Stop the pump,
•
Turn the mulitport valve to the "DRAIN" position,
•
Open the valve on the waste line,
•
Close the skimmer and vacuum point valves,
•
Turn the motor on,
•
Lower the water level by about 30 cm,
•
Next, drain the filter by unscrewing the drain plug at the base,
•
Close all the valves,
•
Unscrew the drain plugs on the motor,
•
Cut power to the control panel,
•
Store the motor somewhere dry.
•
Put the 6-way valve to "HIVER" (WINTER) (see below).
CONSTRUCTION & RENOVATION
2019/05 - Indice de révision : H - Code : 26680
19/32
Publicité
