MSI MS-7228 Mode D'emploi page 14

MSI Reminds You...
1. Always consult the vendors for proper CPU cooling fan.
2. CPUFAN1 supports the fan control. You can install the PC Alert utility that will automatically control
the CPU fan speed according to the actual CPU temperature.
ID E Connectors: IDE1/IDE2
T he mainboard has a 32-bit Enhanced PCI IDE and Ultra DMA 33/66/100/133 controller that
provides PIO mode 0~4, Bus Master,
up to four hard disk drives, CD-ROM, 120MB Floppy and other devices.
The first hard drive should always be connected to IDE1. IDE1 can connect a Master and a
Slave drive. You must configure second hard drive to Slave mode by setti
accordingly. IDE2 can also connect a Master and a Slave drive.
MSI Reminds You...
If you install two hard disks on cable, you must configure the second drive to Slave mode by setting its
jumper. Refer to the hard disk documentation supplied by hard disk vendors for jumper setting
instructions.
Front Panel Connectors: JFP1/JFP2
The mainboard provides two front panel connectors for electrical
connection to the front panel switches and LEDs.
with Intel Front Panel I/O Connectivity Design Guide.
Front Panel Audio Connector: JAUD1
The front panel audio connector allows you to
connect to the front panel audio and is compliant wi
Intel ® Front Panel I/O Connectivity Design Gui
All manuals and user guides at all-guides.com
and Ultra DMA 33/66/100/133 function. You can connect
JFP1 is compliant
th
de.
8
ng the jumper
Speaker
2
1
Power
LED
JFP2
AUD_RET_R
Key
AUD_VCC
(2)AUD_GND
(1)AUD_MIC
HP_ON
AUD_MIC_BIAS
AUD_FPOUT_R
10
9
Power
Reset
8
Switch
Switch
7
Power
HDD
LED
LED
2 1
JFP1
AUD_RET_L(10)
AUD_FPOUT_L(9)