OPERATING INSTRUCTIONS
ADDING AN ITEM
It is possible to add a forgotten item to the
appliance when a wash program is already
running.
To add a forgotten item:
1. Press and hold the start/pause button for 3
seconds to pause the current program.
2. Wait until the drum stops rotating, the water
level is below the bottom of the door and the
door is unlocked.
3. Add the forgotten item and close the door.
4. Press the start/pause button to resume
functioning.
NOTE
Do not add an item when the water level is higher
than the bottom of the door as this can cause water
to leak out of the appliance.
Caution: The inside of the appliance may be hot.
Use caution when adding a forgotten item to a
wash program.
PROGRAM END
The appliance will automatically stop when the
selected program ends.
1. "End" will appear on the electronic display
2. The door can be opened to remove laundry
3. Turn the program knob to OFF
4. Unplug the machine
5. Turn off the water tap
NOTE
It is recommended the door is left open so that the
inside of the machine can dry
EMERGENCY DOOR RELEASE
In case of a power failure or other circumstances
where the door cannot be opened, there is an
emergency door release on the front of the
appliance.
1. Turn off and unplug the machine.
2. Drain the water by following the instructions for
cleaning the pump filter section.
3. Pull down the emergency opening mechanism
with the help of a tool and open the door at the
same time.
4. Move the emergency opening handle to the
open position after being closed again
5. Repeat steps 3 and 4 if the door remains locked.
IMPORTANT: Do not force open the door if the
appliance is still filled with water. The water will
flood the room.
12