Craftworx 1A-MS501 Manuel D'instructions page 11

WARNING
To assemble the stand and motor, review the components diagram as shown in Figure 1 and the
Parts List on page 10. You may choose to begin assembling the stand first and gradually add all other
components. The motor housing may be attached last. Once assembled, attach the Rubber Feet to the
four corners of the stand. The feet will help reduce vibration when the saw is in use. NOTE: When
installing the Motor Support Plate (Part # 20), it must angle toward the front, otherwise the
motor will not line up properly with the Drive Wheel in the upper housing. Ignore the holes on
top of Part # 19, as they serve no purpose. Once the stand and motor are assembled, attach it to
the main body of the saw using three long bolts, through the three elliptical openings (A) in the Upper
Cover (Part # 14).
Figure 1
12