Key Automation EGKTB1 Instructions Et Avertissements Pour L'installation Et L'usage page 11

4.3.1 – CREATE USER CODES AND CHANGE THE OPERATION OF K1 AND K2
In the following example, the user code that will be created can only operate relay K1.
DESCRIPTION
Start the procedure by pressing and holding the
simultaneously keys
keyboard turns blue
Type the master code
Type followed by the new four-digit code and the
operating code (see table), conclude by typing
Repeat the previous sequence
CODE
00
01
02
03
4.3.2 - CREATE USER CODE WITH LIMITED ACCESS
The administrator can limit the number of activations that a user can perform. The number of accesses
that can be assigned ranges from one to nine. At the end of the operations, the code will be deleted.
DESCRIPTION
Start the procedure by pressing and holding the
simultaneously keys
keyboard turns blue
Type the master code
Type followed by the new four-digit code followed by
and the number of accesses you want to assign
Repeat the previous sequence
4.3.3 – ASSIGN SPECIFIC FUNCTIONS TO RELAYS AND PROPERTIES TO USERS
Each of the two relay outputs can behave as timed (preset 1" ON) or bistable. In timed operation, the
activation time can be varied. In addition, it is possible to determine which output relay(s) each user
can activate (the default is both relays enabled) and whether it is enabled to change its user code. To
configure the specific features, refer to the 580PADW product instructions downloadable from www.
keyautomation.it.
4.3.4 - PAIRING MULTIPLE KEYBOARDS TO A DECODER
After pairing the keyboard T1 with the decoder D1 and defining the number of digits of the codes, it is
possible to add additional keyboards, in this case T2. After wiring the new keyboard, proceed as follows:
Press and hold the P key on keyboard T2 until the colour
turns RED
On the decoder, within 20", press briefly and release the
button; the green LED remains on for a long time.
Wait a few seconds, the keyboard emits three long BEEPS
On the decoder, the green LED turns off briefly and then
flashes again at a frequency of 1"
and until the lighting on the
and until the lighting on the
EXAMPLE COLOUR
DESCRIPTION
all disabled
relay K1 enabled
relay K2 enabled
relays K1 and K2 enabled (default)
EXAMPLE COLOUR
+ 5
BLUE
sec. max
ORANGE
1234
2022
YELLOW
01
2022
GREEN
01
+ 5
BLUE
sec. max
1234 ORANGE
2 0 2 2
YELLOW
3
2 0 2 2
GREEN
3
RED
GREEN
GREEN
BEEP
> 1 s
+ > 1s
> 1s x3
+ > 1s
BEEP
> 1 s
+ > 1s
> 1s x3
+ > 1s
> 1 s
> 1s x3
11