Key Automation EGKTB1 Instructions Et Avertissements Pour L'installation Et L'usage page 10

DESCRIPTION
Start the procedure
simultaneously keys
keyboard turns blue
Type the master code (unless it has already been changed)
Type the number of digits the code should consist of
(example: 3)
Repeat the previous sequence
Now the master code is 123.
PLEASE NOTE: each keyboard and/or decoder that will be added later will inherit the number
of digits set on the first pair of devices. In the explanations below, the user codes are made
of four digits.
4.2 - CHANGE THE MASTER CODE
Until now, the only existing code is master code 1234 and is enabled to operate both relays K1
and K2. It allows the performance of all system configuration operations, therefore it should not be
disclosed for safety reasons.
PLEASE NOTE – some codes cannot be used because they are reserved for other functions.
In case of three-digit codes, do not use the number 001.
In the case of four-digit codes, do not use numbers 0020 to 0029 (included).
4.2.1 – CHANGE THE MASTER CODE AND OPERATION OF K1 AND K2
In the following example, the operation of both relays will be disabled.
DESCRIPTION
Start the procedure by pressing and holding the
simultaneously keys
keyboard turns blue
Type the master code (unless it has already been changed)
Type the new four-digit code followed by the operating code
(see table), conclude by typing
Repeat the previous sequence
PLEASE NOTE: code 00 HAS been entered, therefore by typing the master code followed by
no relay will be activated, the keyboard lighting will turn red and three short beeps will be emitted
(incorrect code). Below is the list of operating codes that can be used:
CODE
00
01
02
03
4.3 – CREATE USER CODES
Up to 50 user codes can be added.
PLEASE NOTE – some codes cannot be used because they are reserved for other functions.
In case of three-digit codes, do not use the number 001.
In the case of four-digit codes, do not use numbers 0020 to 0029 (included).
10
by pressing and
and until the lighting on the
and until the lighting on the
EXAMPLE COLOUR
holding the
EXAMPLE COLOUR
2 0 2 0
2 0 2 0
DESCRIPTION
all disabled
relay K1 enabled
relay K2 enabled
relays K1 and K2 enabled (default)
+ 5
BLUE
sec.
max
ORANGE
1234
YELLOW
3
GREEN
3
+ 5
sec. BLUE
max
1234 ORANGE
YELLOW
0 0
GREEN
0 0
BEEP
> 1 s
+ > 1s
> 1s x3
+ > 1s
BEEP
> 1 s
+ > 1s
> 1s x3
+ > 1s
or