Sinbo SJ 3138 Mode D'emploi page 9

All manuals and user guides at all-guides.com
ATTENTION BEFORE USING
1. This machine is set with safety unit, when the handle does not fasten
the cover or the cutter seat is not fastened, the motor cannot turn, so as to ensure safety
for the user.
2. When disassembling or assembling the juicer, press the upper of feed port of the cover
with your hand, then force the handle to slide in or out of cover slot.
3. When disassembling juicing net, first remove the cover and residue barrel, then turn
the middle ring up to 30 degrees by holding juicing nozzle with your hand, and take up,
the juicing net will automatically leave the rotor.
4. In order to avoid damage, before using, first check power supply for compliance with
rated voltage .
5. Clean all parts able to disassemble (refer to the section of "maintenance and cleaning").
6. When assembling, please carefully read the diagram of "name and position of main
components".
7. Please carefully read the "attentions" before using.
JUICING
1. Before using, please confirm the button switch of the main machine in stop state, in
this way, in case assembly is not completed, starting the main machine can be avoided,
so unnecessary damage for persons or property avoided.
2. Before juicing, first confirm juicing net and rotor clutched in position, and no hard
contact between juicing net cutter and transparent cover. Put the transparent cover on,
put the handle into the cover slot, then turn on the machine.
3. For using, assemble according to the diagram of "name and position of main
components". Turn on power supply, press switch to let the machine run no-load for 5
sec. Put prepared vegetable or fruit into feed port of the juicer, press with the pushing
bar, evenly, hard and slowly, juice of the vegetable or fruit can be found, original, fresh,
good for health.
4. Note: When pressing food with the pushing bar, force shall be even or indirect, pressing
force shall not be more than 1 kg, no too sudden force, otherwise, juicing effect will be
reduced.
OPERATING TIME
This machine is designed with button switches of O grading, I grading, II grading (O for
stop, I for weak grading, II for strong grading). For juicing, select strong grading, for
operating time, after operating for 1min, stop for 1min, then use again. After the above
operation is performed for three times, stop for 15 min, do not operate until the motor
is cooled, in this way, service life of this machine will be prolonged, the machine will
serve you more efficiently.
ATTENTIONS
1. This machine is unavailble for the weakness, unresponsive or psychopathic
-8 -