Publicité
12
English
Remove any obstacle before beginning work.
3. Inspect the entire unit for loose fasteners and fuel
4. Be sure the debris guard is firmly attached in place.
5. If the cutting head is the metal blade, change the
■ STARTING THE ENGINE
1. Keep bystanders and animals at least 50feet (15m)
2. The product is equipped with a centrifugal clutch
Make sure the throttle is at idle position.
Never place the throttle into the high speed
position or half throttle position (throttle lock
position) when starting the engine.
3. After starting the engine, check to make sure that
■ USING THE PRODUCT
Cut only materials recommended by the
manufacturer. And use only for tasks explained in
the manual.
Get other manuals https://www.bkmanuals.com
5. For safe operation
IMPORTANT
leakage. Make sure that the cutting attachment is
properly installed and securely fastened.
guard and handle, and attach the shoulder strap
(see p42). Adjust the strap before starting the engine
at the position that your left hand can comfortably
hold the handlebar grip approximately waist high.
away from the operating point. If you are
approached, immediately stop the engine.
mechanism, so the cutting attachment could rotate
as soon as the engine is started. When starting the
engine, place the product onto the ground in a flat
clear area and hold it firmly in place so as to ensure
that neither the cutting part nor the throttle come into
contact with any obstacle when the engine starts.
WARNING
the cutting attachment stops rotating when the
throttle is moved fully back to its original position
(idle position). If it continues to rotate even after the
throttle has been moved fully back, turn off the
engine and take the unit to your authorized Red Max
servicing dealer for repair.
IMPORTANT
Publicité
