Publicité
31
34
14
32
31
30
14
5
All manuals and user guides at all-guides.com
ASSEMBLY INSTRUCTION
FIG1
FIG3
1. Carefully lift (as shown in Fig 2) the frame (#7) from the rear.
Remove console (#13), handlebars (#14) first then remove the
styrofoam (#3 & 4) from underneath.
2. Lower the frame carefully.
3. Remove screws (#23) from the left and right of the base frame (Fig 3).
4. Raise the left and right support bars (#8 & 9) to the upright position.
5. Refit the screws (#23) but do not tighten yet.
1. Reinstall the handlebar assembly (#14) onto the support bars (8 and 9).
Connect the PCB upper cables (#21) and the lower PCB
cables (#22) together and tuck cables into the tube.
2. Secure the handlebar set to the support bars with 4 screws
(#24) as shown (Fig 4).
3. Tighten the screws (#23) of the base frame (Fig 3).
FIG4
1. Remove the screws (#25) from the back of the console (Fig 5).
2. Connect PCB cable lower (#17) and PCB cable upper (#19).
3. Connect hand pulse cable lower (#18) and hand pulse cable upper (#20).
4. Fit console to console bracket and tighten the screws (#25).
Note: You can adjust the position of the console by loosening and
tilting the console foward or back. When adjusted, tighten screw (#28).
FIG5
LS-3T:
33
31
1. Remove screws (#31) from the handrails (#14), secure the Left and
35
Right handrail covers (#34) (#35) on the sides of handrails (Fig 6).
32
2. Remove screws (#30) from the water bottle holder and place the
water bottle holder on the water bottle holder support piece (#32),
use screws (#30) to secure them tightly.
30
FIG6
LS-5T/7T:
30
1. Place the water bottle holder (#32) onto the compartment rack (#31).
Gently press down until it snaps into place (Fig 7).
2. Remove two screws (#30) from the handrail set (#14), place the
compartment rack (#31) and the water bottle holder (#32) onto the
handrail set (#14). Make sure the holes are in position and tighten it
with screws (#30).
FIG7
FIG2
Upright Assembly
Handlebar Assembly
Console Attachment
Publicité
