Publicité
Aligning the running belt
Ensure the running belt is centered on your treadmill at all times.
Running style and a non-level surface are two instances that may
cause the belt to drift off center. Minor adjustments to the two
bolts at the rear of the treadmill are necessary when the belt has
drifted off center.
1. Press "START" to begin running belt, then increase the treadmills
speed to 5 km/h (3mph).
2. Stand at the rear of the treadmill to determine which direction the
belt is drifting.
3. If the belt drifts to the left, turn the left adjustment bolt with 6 mm
Allen wrench 1/4 of a turn clockwise. (FIG. C)
4. If the belt drifts to the right, turn the right adjustment bolt with 6 mm
Allen wrench 1/4 of a turn clockwise. (FIG. D)
5. Observe the tracking of the belt for about 30 seconds. Repeat
previous steps if needed.
Belt lubrication
Use only 100% Silicone and avoid using aerosol silicone sprays which include additives and petroleum distillates.
One ounce of Silicone should be used for each application. LifeSpan offers 100% silicone lubricant that can be ordered at
www.lifespanfitness.com.
The running belt should be lubricated every 3 months (regardless of use) or every 50 hours of use, whichever comes first.
Even if the treadmill is not being used, silicone will dissipate over time and the belt will dry out.
Note: Even though the running belt is lubed from the manufacturer, it is not a bad idea to lubricate the running belt when first
using the treadmill in case the belt has dried some between the dates the unit was manufactured and when it was purchased.
Apply the silicone to the underside of the treadmill belt. Do ot apply to the walking surface.This may be accomplished by
folding the treadmill and applying the silicone to the back of the belt from each back corner. Spray the silicone down and
across the belt from each corner. Rotate the belt 1/2 of the circumference and repeat from each corner.
Note: When lubricating the belt, make sure the treadmill is located on a surface that can be easily cleaned. After lubricating
your treadmill running belt, clean any excess silicone off the belt and frame.
Cleaning
It is recommended to wipe the treadmill down after each use to keep the treadmill clean and dry. A mild detergent may be used
at times to help remove all dirt and salt from the belt, painted parts and the display.
Cleaning would include removing the motor cover and cleaning around the motor and electronics. It is recommended to clean
the motor compartment if the treadmill is in an area where there might be a lot of pet hair or plush carpet fibers that could get
pulled up into the motor compartment. It is a good idea at this time to check and tighten all assembly hardware as well.
Warning: Unplug the Power Cord Before Removing the Motor Cover.
All manuals and user guides at all-guides.com
MAINTENANCE
To move belt to the Right
FIG C.
To move belt to the Left
FIG D.
12
Publicité
