General International BG8002 Manuel D'instructions page 7

UNPACKING
REMoVE ALL THE PARTS FRoM THE BoX
NoTE: If any part is missing or damaged, do not
plug in your tool until the missing or damaged part
is replaced.
Your grinder is fully assembled in the carton with the
exception of some small parts.
Carefully unwrap the two flexible LED work lights
from around the base.
Item Description
D Eye shield
E Spark deflector / shield mount
assembly (attached)
Bolt long (part of assembly above)
Nut (part of assembly above)
Flat washer (part of assembly above)
Lock washer (part of assembly above)
B Left hand tool rest
I Right hand tool rest
Carriage bolt (short)
Flat washer
Lock washer
j Tool rest locking knob
M Locking knob
AssEMBLY AND sETUP
wARNING
!
To reduce the risk of injury, never connect plug to
power source outlet until all assembly steps are
complete and until you have read and understood
the entire owner's manual.
All manuals and user guides at all-guides.com
Qty.
2
2
2
2
2
2
1
1
2
2
2
2
2
!
5
ATTACHINg SPARK DEFLECToRS AND
EYE SHIELDS
1. Remove the bolt from the top of the wheel
guard.
2. Position the spark deflector at the top of the
wheel guard.
3. Re-insert the bolt through both the spark
deflector and wheel guard, followed by the
washer, lock washer and locking knob.
Note: Always check to ensure the eye shields are
correctly fitted and the eye shield spark deflectors
are correctly adjusted each time the grinder is used.
Eye shields and spark deflectors must be fitted over
each grinding wheel.
ATTACHINg TooL RESTS
Tool rests are required for each high speed grinding
wheel to assist in the grinding operation.
wARNING
!
To reduce the risk of injury, never use a bench
grinder on which the tool rest has not been fitted
or where the tool rest has not been correctly
adjusted.
Note: The tool rests are right and left handed.
Follow the diagrams to ensure the correct tool rest
is fitted to the correct side.
wARNING
!
To reduce the risk of injury, never connect plug to
power source outlet until all assembly steps are
complete and until you have read and understood
the entire owner's manual.
1. Hold the tool rest in the correct position against
the tool rest bracket (N, fig 6) on the wheel
guard.
!
!