Publicité
Les langues disponibles
Les langues disponibles
symptOm
Lights will not come
on.
Lights come on in
daylight.
Lights come on for no
apparent reason.
Lights stay on continu-
ously.
Lights flash on and
off.
Light does not stay on
in Manual mode.
598-1338-03
All manuals and user guides at all-guides.com
trOuBLeshOOting guiDe
pOssiBLe Cause
1. Light switch is turned off.
2. Lamp is loose or burned out.
3. Fuse is blown or circuit breaker is turned
off.
4. Daylight turn-off is in effect.
5. Incorrect circuit wiring, if this is a new
installation.
1. Light control may be installed in a relatively
dark location.
2. Light control is in TEST.
Light control may be sensing small animals or
automobile traffic.
1. The sensor may be picking up a heat source
like an air vent, dryer vent, or brightly
painted, heat-reflective surface.
2. Sensor is in Automatic Override or Manual
Override mode.
1. Heat being reflected from other objects
may be affecting the sensor.
2. Sensor is in the Test mode.
Nearby large, light-colored objects reflecting
light may trigger the shut-off feature.
sOLutiOn
1. Turn light switch on.
2. Check lamp and replace if burned out.
3. Replace fuse or turn circuit breaker on.
4. Recheck after dark.
5. Verify wiring is correct.
1. The fixture is operating normally under these
conditions.
2. Set control switch to 5 or 10 minutes or Dusk-to-
Dawn.
Reduce sensitivity.
1. Reduce sensitivity.
2. Set control switch to 5 or 10 minutes.
1. Reduce sensitivity.
2. While in TEST mode, light only stays on for 5
seconds.
Do not point other lights at the sensor.
7
Publicité
