Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION
Replacing vacuum nozzle and lock spring
The vacuum nozzle and the locking spring
are consumable parts, which need to be
changed if worn.
1. Unscrew and remove the old vacuum
nozzle.
2. Insert the locking spring into the new
vacuum nozzle. Attach the new vacuum
nozzle and start screwing it. Tightening
of the vacuum nozzle will be done as
final action after inserting gas nozzle.
Replacing gas nozzle
The gas nozzle is a consumable part, which
needs to be changed if worn.
1. Loosen the vacuum nozzle and remove
the old gas nozzle.
2. Insert the new gas nozzle.
3. Tighten the vacuum nozzle to lock the
new gas nozzle in place. Hold the torch
with the tip up to make tightening easier.
Replacing vacuum hose cover
ERGOFRESH welding torch's vacuum hose
comes with a leather cover, attached with
cable ties.
The vacuum hose leather cover is a
consumable part, which needs to be
changed if worn.
1. Remove the old leather cover.
2. Wrap the new leather cover around the
vacuum hose.
3. Close the hook-and-loop fastener and the
two cable ties on the ends.
All trademarks are the property of their respective owners. The information and images are indicative and may be subject to change at any time without notice.
NOTE! All parts must be installed. Do not remove or adjust any parts during
welding.
The gas nozzle comes out if the vacuum nozzle is not installed..
1
1
1
2
3
© 2023 Trafimet Group SpA
2
2
3
5
Publicité
