Westfalia Wetelux 95 19 40 Mode D'emploi Originale page 8

Intended Use
The solar pump has been designed for fountain, pond or outdoor use; the Pump
drives its power from a solar module directly. In order for the pump to operate,
the solar module needs to be placed in direct sunlight. The performance of the
pump depends on the season and the position of the solar module.
Assembling and Setting up
 Unpack and check all components.
 Unroll the pump cable
 Place the pump underwater. Make sure that when the pump operates, it is
fully underwater. Choose which plastic tubes and fountainheads to use
according to your preference or alternatively use a PVC hose (not included).
 Attach the ring with the LEDs so that the fountain is illuminated.
 Set up the solar panel too face the sun and connect it to the pump with the
included cable.
Attention: Do not allow the pump to run dry, do not lift the pump by the power
cord, operate in freshwater only and do not strike the solar panel
Operation
Briefly touch the "ON / OFF" keypad to switch on the pump. The pump now runs
as long as energy is available and switches on again the next day at the same
time (24 hours after switching on). To switch off the pump, press the "ON / OFF"
keypad for 3 seconds.
After you have pressed the keypad for 3 seconds, the solar panel charges the
battery as long as sunlight is available.
Charging State
The charge status LED shows the current charge status of the battery:
Green: the battery is fully charged. The pump runs for approx. 2-4 hours.
Orange: The battery is half charged. The pump runs for about 1-2 hours.
Red: The battery needs to be charged. The pump runs for less than half an hour.
Note: The indicator light flashes when the pump is switched on. The control lamp
lights up continuously when the pump is switched off.
Handling solar pumps
 The output of the solar pump varies depending on the season, depending on
the duration and strength of the sunlight received.
Operation
8