Télécharger Imprimer la page

La Pavoni EDL Mode D'emploi page 9

Publicité

Les langues disponibles

Les langues disponibles

• Push the main switch (2). The warning light in the switch
turns on, to indicate that the machine is under voltage
(Fig. B). The "Eurobar" and "Eurobar de Luxe" models
are equipped with an active cup-heater (16) which begins
working by operating the main switch (2).
• Turn the hot water/steam knob (13) anti-clockwise, about
one turn (Fig. C).
• Place a container under the Turbo Cappuccino (14).
• Push the coffee switch (3), and wait until the water flows
evenly (Fig. D).
• Move the knob (13) back to its starting position, turning
clockwise. The water will now flow through the boiler group
(11).
• Turn off the coffee switch (3). Now the machine is ready
for normal operation.
• Before first use only, it is recommended to add two spoonfuls
of bicarbonate to the water, in order to clean the circuit of
possible impurities.
• Rinse the tank (12) and repeat the STARTING UP procedure,
in order to clean off the bicarbonate residues.
wARNING
• The procedure set out on this page should be repeated every time the tank (12) runs out of water, or
after the machine has been out of use for a long period.
• Never use the machine when the water tank is empty.
• The machine is equipped with an active cup-heater (16) keeping the temperature of the cups automa-
tically constant.
All manuals and user guides at all-guides.com
fig. B
fig. C
fig. D

COFFEE PREPARATION
• The special pressurized filter holder ensures the preparation
of a good and creamy genuine espresso coffee.
• Insert the filter holder (6) under the boiler group (11) and
turn it from left to right until it locks, in order to pre-heat it.
Leave the filter holder handle (Fig. E).
• The handle will now automatically turn slightly back to the
left. This little movement ensures the perfect operation of
the filter holder, for a long time.
• Check the water level in the tank (12) is enough for the
amount of coffee wanted.
• Push the main switch (2).
• Wait until the warning light in the coffee switch (3) turns on
(Fig. F).
• Now the machine has reached the right temperature to pump
water.
• Remove the filter holder from the boiler group (11) and insert
the big filter for coffee (17) into the filter holder (6).
• Fill the filter (17) with one or two measuring spoons of ground
coffee according to the number of coffees to be prepared
(fig. G).
about 1 measure = 1 coffee
about 2 measures = 2 coffees
• The quantity and pressing of the coffee powder directly affect
the quality and flavour of the espresso.
• Slightly press the coffee with the measuring spoon (5), then
clean the filter holder brim of any coffee residues (Fig. H).
• Install the filter holder (6) in the boiler group (11), as described
above.
• Put two pre-heated cups under the filter holder.
• Push the coffee switch (3). When the required amount of
coffee has run into the cups, turn the coffee switch off.
• After having made coffee, remove the filter holder and empty
the coffee grounds. Then, rinse the filterholder under running
water
fig. E
fig. F
fig. G
fig. H


Publicité

loading

Ce manuel est également adapté pour:

EtbEbrEts