Fellowes AeraMax Baby DB55 Mode D'emploi page 3

SAFETY INSTRUCTIONS/WARNING
WARNING: Follow the instructions in this manual to reduce the risk of electric shock, short circuit, and/or fire:
repairs should be completed by a qualified technician.
plug. If it still does not fit, contact a qualified technician to install a proper outlet.
Do not use if the power cord or plug is damaged or the connection to the wall outlet is loose.
Do not damage, break, forcefully bend, pull, twist, bundle, coat, pinch, or place heavy objects
on the power cord.
will accumulate, which increases the risk of electric shock.
or similarly qualified persons in order to avoid a hazard
Remove the power plug from the outlet before cleaning the unit. When removing the
power plug, grasp by holding the plug itself, never hold by the cord.
Do not use the unit where it is humid or where the unit may get wet, such as in a bathroom.
SET-UP AND OPERATION
NOTE: follow these instructions for best results
Place unit at least ½ meter from the wall. Keep unit away from drafty areas. Keep curtains
away from unit, as they may interfere with air intake/outlet. Place unit on a stable surface with
plenty of air circulation.
1. Remove protective film from the control panel.
2. Pull out drawer.
3. Remove bag from filters. Place filters back in unit.
4. Insert Carbon Filter first and then True HEPA Filter.
5. Fully insert drawer into unit until click is heard.
6. Plug in the power cord to a wall outlet.
7. Turn unit on. Unit will beep.
For approximately the first 4 minutes after turning the unit on, the indicators will flash while
the unit measures air quality.
CARE AND MAINTENANCE
CLEANING:
Clean unit as necessary by wiping with a dry, soft cloth; for stubborn stains, use a warm, damp cloth. Do not use volatile fluids such as benzene, paint thinner, or scouring powder, as they may
damage the unit surface. Keep the unit dry.
TROUBLESHOOTING: Solutions to common problems
Review this list before you call for service. This list covers problems that are not the result of defective materials or workmanship.
PROBLEM:
The unit leaves smoke and odors in the air.
The unit seems to produce odors.
The unit makes a faint ticking sound.
The unit interferes with radio or television reception.
The True HEPA and Carbon Filter indicators remain lit after replacing the
True HEPA and/or Carbon Filter.
The PlasmaTRUE™ icon is not illuminated.
The wrong filter replacement light was reset.
The display panel buttons will not work.
Do not use the unit near flammable gases. Do not use near cigarettes, incense, or
other spark-creating items.
sources.
into contact
with steam.
Do not operate without a filter.
Do not wash and reuse the True HEPA Filter.
with reduced physical, sensory or mental capabilities or lack of experience and
knowledge if they have been given supervision or instruction concerning use of
the appliance in a safe way an understand the hazards involved. Children shall
not play with the appliance. Cleaning and user maintenance shall not be made by
children without supervision.
FILTER REPLACEMENT:
The replacement filter indicators will signal when to replace the True HEPA Filter and/
or Carbon Filter. The replacement period will vary depending on the hours of use and
air quality. However, under normal usage, most True HEPA Filters need to be replaced
annually, and Carbon Filters every three months.
Do not wash and reuse the True HEPA or Carbon Filters—they will not work effectively.
Only use Fellowes brand AeraMax™ replacement filters.
Before replacing any filters, make sure to remove the power plug from the
WARNING:
wall outlet.
FILTER INDICATOR RESET:
1. Be sure that the drawer is closed.
2. Turn on the unit.
3. Locate the filter replacement icon on the display panel.
4. Touch and hold the filter replacement icon for 3 seconds. HEPA Filter icon will flash
amber. Touch filter icon area to alternate between HEPA and Carbon.
5. Once desired filter is illuminated, touch and hold for 3 seconds. A short beep will be
heard and the light should turn off. Repeat process for each filter as needed.
POSSIBLE SOLUTION:
Make sure the sensor is not blocked or clogged. Move the unit closer to the offending odors. Replace the filters as needed.
Replace the filters as needed.
This indicates that the PlasmaTRUE™ function is working.
Because this unit radiates radio frequency energy, we suggest you try one or more of the following:
- For better reception, adjust the television/radio antenna.
- Move the unit away from the affected television/radio.
- Plug the unit power cord into an outlet different from the television/radio power cord.
Touch and hold PlasmaTRUE™ icon for five seconds until unit beeps.
minutes of unintended reset. The filter counter and indicator will return to the status previous to the reset.
Touch and hold the Night Mode/Child Lock icon for five seconds until it beeps.
3