Maintenance; General Maintenance; Troubleshooting - Skil LH5534-00 Guide D'utilisation

Projecteur d'illumination de 20 v
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

MAINTENANCE

WARNING
Service
WARNING
cause serious hazard.
Service Center or Authorized SKIL Service Station.

General Maintenance

WARNING
NOTE: Periodically inspect the entire product for damaged, missing, or loose parts such as
screws, nuts, bolts, caps, etc. Tighten securely all fasteners and caps and do not operate this
product until all missing or damaged parts are replaced. Please contact customer service or
an authorized service center for assistance.
Cleaning
WARNING
Ventilation openings and switch levers must be kept clean and free of foreign matter. Do not
attempt to clean by inserting pointed objects through openings.
WARNING
ammonia and household detergents that contain ammonia.
Storage
Store the tool indoors in a place that is inaccessible to children. Keep away from corrosive
agents.

TROUBLESHOOTING

Problem
Flood light does not
illuminate.
Flood light flashes slowly
then goes out.
To avoid serious personal injury, always remove the battery pack
from the tool when cleaning or performing any maintenance.
Preventive maintenance performed by unauthorized personnel may
result in misplacing of internal wires and components which could
We recommend that all tool service be performed by a SKIL Factory
When servicing, use only identical replacement parts. Use of any
other parts could create a hazard or cause product damage.
The tool may be cleaned most effectively with compressed dry air. Always
wear safety goggles when cleaning tools with compressed air.
Certain cleaning agents and solvents damage plastic parts. Some of
these are: gasoline, carbon tetrachloride, chlorinated cleaning solvents,
1. Battery pack is depleted.
2. Battery pack is not
installed properly.
3. The two light heads are
folded to close.
4. Damaged button.
Battery pack is depleted.
Cause
Remedy
1. Charge the battery.
2. Confirm that the battery is
locked and secured to the
tool.
3. Unfold the two light heads.
4. Contact an Authorized
SKIL Service Center or
Service Station.
Charge the battery.
13

Publicité

Table des Matières
loading

Table des Matières