Operating Instructions - Skil LH5534-00 Guide D'utilisation

OPERATING INSTRUCTIONS

WARNING
allow a fluid to flow inside them. Corrosive or conductive fluids, such as seawater, certain
industrial chemicals, and bleach or bleach-containing products, etc. can cause a short circuit.
WARNING
could result in serious personal injury.
WARNING
is misuse and could result in a hazardous condition leading to possible serious injury.
WARNING
parts, making adjustments, cleaning, or performing maintenance.
This cordless flood light must be used only with the battery packs and chargers listed below:
2Ah
SKIL BY519701
SKIL BY519702
NOTICE: Please refer to the battery and charger manuals for detailed operating information.
To Attach/Detach Battery Pack (Fig.2)
To attach the battery pack:
Align the raised rib on the battery pack with the
grooves of the tool, and then slide the battery
pack onto the flood light.
NOTICE: Make sure that the latch on the
battery pack snaps into place and that the
battery pack is secured to the flood light before
beginning operation.
To detach the battery pack:
Depress the battery-release button located
on the front of the battery pack to release the
battery pack. Pull the battery back out and
remove it from the flood light.
Three-Stage Brightness
Adjustment Controlled by On/Off Button
Your flood light is equipped with a three-stage brightness adjustment, providing different light
intensities for your operation.
Depress the ON/OFF button to scroll through the following reactions:
High light mode: both the upper and the lower lights illuminate at full brightness.
•
Low light mode: both the upper and the lower lights illuminate at half of their full brightness.
•
Upper light mode: the upper light illuminates at half of the full brightness and the lower light is turned off.
•
Turn off your flood light.
•
10
To reduce the risk of fire, personal injury, and product damage due to a
short circuit, never immerse your tool, battery pack or charger in fluid or
If any parts are damaged or missing, do not operate this product until
the parts are replaced. Use of this product with damaged or missing parts
Do not attempt to modify this tool or create accessories not
recommended for use with this tool. Any such alteration or modification
To prevent accidental starting that could cause serious personal
injury, always remove the battery pack from the tool when assembling
Battery Pack
2.5Ah
SKIL BY519703
4Ah
SKIL
SKIL BY519603
BY519601
Fig. 2
Battery-Release
Button
Charger
5Ah
SKIL SC535801
SKIL QC536001
Attach
Detach