Jensen JE1913AC2 Mode D'emploi page 21

TV Setup
Initial Setup Wizard
Setup Wizard only appears when fi rst turning the TV on and without channel scanning.
After connecting your TV antenna or cable wire, turn the television ON. The quick setup wizard will display on-screen.
Select your preferred Picture setting followed by antenna options and performing Auto Scan to receive local broadcast
channels that will be stored in the TV tuner memory.
The wizard will direct you to the TV menu to select antenna options and perform
Channel Auto Scan. Channels found will be stored into the TV tuner memory.
Setup Wizard
Menu Language
Air/Cable
Cable System
Auto Scan
Move
How to Navigate:
Press the arrow button to highlight AIR/CABLE based on your antenna connection.
•
Press the arrow button to select Auto Scan and press
•
erwise, press the arrow button to select STD > IRC > HRC > Auto
Setup Wizard
Menu Language
Air/Cable
Cable System
Auto Scan
Move Select
Highlight Start to Scan and press ENTER.
•
Channel Auto Scan may take several minutes to complete.
•
Air/Cable Cable
Auto Scan
Favorite
Show/Hide
Channel No.
Channel Label
DTV Signal :
Move Select
All manuals and user guides at all-guides.com
English
Cable
AUTO
Select Exit
English
Cable
AUTO
Note: Auto Scan time will vary and could take up to
60 minutes to complete.
Exit
Cable System
Start to Scan
Note: Auto Scan time will vary and could take up to
60 minutes to complete.
Return Move
Initial Setup Wizard
(when Cable is selected, 'AUTO' is recommended). Oth-
Setup Wizard
RF CH : 1
Found : 0
Move Select
Next
AUTO
Next Return
20
Exit
RF CH : 1
Found : 0
Move Next Return