Faber GV60TT/10 Mode D'emploi page 13

2.6.3 Switching off the fire

Press the OFF-key and the fire will be
switched off completely. (fig. 1.8)
2.7
Only for appliance with step
burner
2.7.1 Switch the Step burner
Note: the step burner will not operate for
45 sec. after the start-up procedure.

Press the SET and the
flame) simultaneously and the flame
picture will concentrate in the middle
of the burner. (fig. 2.2).

Adjusting the flame height see 2.6.2

Press the SET and the
flame) simultaneously and the flame
picture will divide over the complete
length of the burner. (fig. 2.1) the
AUX symbol appears in the display

Adjusting the flame height see 2.6.2
2.8
Thermostat and Timer Function
The following settings are possible in the
thermostat function:

Day temperature

Night temperature
If the thermostat function is used, the remote
control unit should be placed in the wall
bracket (fig. 2.4/2.5/2.6), this should be
mounted within 4 metres of the hearth in the
same room.
The timer function (TIMER) can make the
thermostat function once or twice on day
temperature and one or twice on night
temperature during a period of 24 hours.
Factory settings thermostat and timer:
Day temperature 23°
Night temperature (appliance doesn't switch
Timer P1  6:00 (getting up)
P1  8:00 (departure)
P2  16:00 (homecoming)
P2  22:00 (night)
Example setting one switch period:
Day temperature
Night temperature
Timer P1  8:00
P1  22:00
2.9
Additional functions
All manuals and user guides at all-guides.com
-key (small
-key (large
(TEMP)
(TEMP)
on)
21°
(appliance doesn't
switch on)
(getting up)
(night)
The display screen on the remote control unit
always shows one of the functions below:
By pressing the the SET-key (fig. 1.6) briefly,
the various functions can be shown
consecutively.
MAN

TEMP
TEMP 
manual operation.
MAN
If the indication MAN is shown in the display
screen, the hearth can adjusted to a higher or
lower flame position by pressing the
the -key (fig. 1.9 of 2.0), see paragraphs. 6.2
en 6.3.
NOTE: By pressing the
(fig. 1.9 of 2.0), the manual operation is
switched on and the active thermostat and/or
timer programmes are switched off.
TEMP
Day temperature
If the indication for day temperature is shown
in the display screen, the thermostat will
make sure the environmental temperature
agrees with the settings for day temperature.
TEMP
Night temperature
If the indication for night temperature is
shown in the display screen, the thermostat
will make sure the environmental
temperature agrees with the settings for night
temperature.
Timer function
TIMER
In this "clock thermostat" function the
duration of the periods for day and night
temperatures is set within 24 hours.
2.9.1 Setting day and night
temperatures

Move the SET-key (fig. 1.6) step by
step to TEMP.

Now keep the SET-key (fig. 1.6)
pushed in for a long time until the
temperature indication in the display
screen starts to blink.

In accordance with your wishes,
increase the Day temperature with
the -key (fig. 1.9) or lower it with
the -key (fig. 2.0).

Press the SET–key (fig. 1.6) again,
now TEMP appears in the display
screen.
ENG

TIMER
-key or
- key or the -key
12 < < < <