Faber GV60TT/10 Mode D'emploi page 12

ENG
should always be placed within 4 metres of
the hearth.
2.4.1 Adapter/batteries
Although a net adapter is supplied, the
receiver can also run on batteries. In case you
use an adapter, don't use batteries as well!
2.4.2 Placing the batteries in the remote
control unit

Remove the lid at the back of the
remote control unit. (fig. 2.1)

Place a 9Volt MN1604/6LR61 Alkaline
long life battery.

Close the lid.
2.4.3 Placing the batteries in the
receiver

Take the receiver (fig. 1.2) out of the
gas block support.

Remove the lid of the receiver.

Place 4 times 1,5Volt AA/LR6 Alkaline
long life batteries (fig. 2.2).

Close the lid and replace the receiver
set in the gas block support.
2.4.4 Replacing empty batteries

Handset: if the indication BATT
appears in the top left corner of the
display screen, the batteries of the
remote control unit need to be
replaced.

After replacing the battery in the
handset, the settings of the
thermostat and timer function have
been reset to the factory settings
(see paragraph 2.8).

Receiver: 3 short sound signals will
be heard when the engine is on to
indicate that the batteries of the
receiver are nearly run down.

When the battery supply is very low,
the remote control unit will switch off
the appliance completely. This will
not happen if the supply is
interrupted.

It is possible that the transmitter
code will have to be set again after
replacing the batteries, see paragraph
5.2 for instructions.
2.5
Setting the controls on the
remote control unit.
2.5.1 Time setting:

Press the - and the -key
simultaneously (fig. 1.4)

The display screen will blink now
11 < < < <
All manuals and user guides at all-guides.com

Press the -key to set the hours (fig.
1. 9)

Press the -key to set the minutes
(fig. 2.0)

Wait or press the OFF- key to
terminate this function (fig. 1.8).
2.5.2 Setting the transmitter code on
the remote control unit:

Press the reset button of the receiver
with a pointed object (fig. 2.4.1),
until the second signal is audible. Now
press the -key on the remote control
unit (fig. 2.0), within 20 seconds. If a
sound signal is audible, the
transmitter code has been set.
2.5.3 Temperature/clock setting
(standard °C/24hours):
The alteration of the temperature
indication on the display screen from
°C/24hours to °F/12hours and the
other way around is done in the
following manner:

Press the OFF-key and the -key
(small flame) simultaneously until
the indication is modified (fig. 1.5).
2.6
Basic functions of the remote
control unit
2.6.1 Switching on the fire

Press the OFF- key and the
simultaneously, until a sound signal is
audible (fig. 1.7).

The start-up procedure will be
executed now. During this period the
receiver will emit a repetitive sound
signal.

The fire will start burning at the
highest position automatically now.
2.6.2 Adjusting the flame height

By twice in rapid succession pressing
the big flame button, will set the fire
to the highest position.

Keep the -key pushed in to increase
the flame height step by step.
(fig. 1.9)

By twice in rapid succession pressing
the small flame button will set the
fire to the lowest position.

Keep the -key pushed in to lower the
flame height step by step and/or to
switch back to the pilot light.
(fig. 2.0)
-key