Seg one CH116 Manual D'utilisation page 17

2. During reception of the DCF time signal, your weather clock radio does not take temperature
measurement. After first time installation, the temperature reading will get stable and become more
accurate in around 30 minutes.
3. As "CH1" is your default channel for main unit. Please always hold the button on "CH1" for
the outdoor temperature sensor.
BATTERY BACK-UP INSTALLATION
In the event that the AC/DC adaptor power is disconnected or a power failure or other interruptions
occur, the back-up batteries will maintain the time and alarm settings. The radio, projection clock, LCD
backlight and the Wake-by-Radio will resume to work when the AC power is restored.
1. Remove the battery cover at the bottom of the clock radio.
2. Insert 3 x AAA batteries (alkaline batteries preferred) by observing the + and - polarity signs inside
the battery compartment.
3. Replace the battery cover, making sure the cover locks into place.
DCF SINGAL RECEPTION AND SIGNAL INDICATOR
After your clock is powered up, it starts to receive DCF signal. The
Weak or no DCF signal
Receiving strong DCF signal
Successful Reception
Failed Reception
TO SET TIME
1. Press SET to enter time set mode, the time digits "0:00" flash.
2. Press + or - on the top of your clock radio to set your desired time. Press and hold - / + will
accelerate setting in faster speed.
TO SET 12HR OR 24 HR TIME FORMAT
1. Then press SET again, the clock display shows 24Hr and flashes.
2. Press + or - to select 12Hr or 24Hr. When 12Hr time format is selected, the PM icon will appear
on the clock display to indicate the afternoon time.
TO SET THE SNOOZE DURATION
1. Press SET again, the clock display shows Zz and "05" flashes.
2. Press + or - to set your desired snooze duration from 5 to 60 minutes.
All manuals and user guides at all-guides.com
(only icon flashing)
( icon flashing)
( icon becomes static)
( icon disappear)
EN. 5
icon flashes.