Zyxel ZyWALL 2 Plus Guide De Démarrage Rapide page 4

4 Look at the front panel. The PWR LED blinks during start-up and stays green once the
ZyWALL is ready. The ACT, LAN and WAN LEDs turn on and stay on if the
corresponding connections are properly made.
If none of the LEDs are on, check your connections, and inspect your
cables for damage. Make sure that you have the power adaptor connected
to the ZyWALL and plugged in to an appropriate power source. Make sure
the power source is turned on. If the LEDs are still off, contact your local
vendor.
2 Accessing the Web Configurator
Use this section to configure the WAN interface for Internet access.
1 Launch your web browser. Enter
192.168.1.1 (the ZyWALL's default IP
address) as the address.
ENGLISH
2 Click Login (the default password 1234
is already entered).
3