Fagor Surf Pro 6 Mode D'emploi page 9

The DC pass is short-circuitable. If there is a short-circuit
the led blinks every second.
Press to validate and return to the main menu.
OK
1.6. Save and exit.
Press to validate and return to the presentation screen.
OK
Surf Pro 6 automatically stores the data programmed after
5 minutes of having modified any parameter.
2. Extended menu
From the presentation screen hold the
during 5 seconds, the display shows the symbol
the left corner when this function is entered.
2.1. Save configuration "* S VE CONFIG"
The UCF 300 Control unit allows saving up to 8 settings
and identify them with a name of 9 letters.
To save a configuration it must be previously memorized
in the Surf Pro 6.
2.2. Load configuration "* LO D CONFIG"
The UCF 300 Control unit allows any memorized configura-
tion to be copied into another Surf Pro 6.
3. Reset
Pressing simultaneously the keys
function is activated to delete the programming, resetting all
parameters to factory default.
Table 1: Configuration UHF Inputs / Filters
Inputs
UHF1 UHF2
6 0
4 2
3 3
Table 2: Operative output level
Nº of nalogic channels, UHF+VHF+ ux 6
RF output level
RISK OF ELECTRIC SHOCK.
DO NOT OPEN.
INDOOR USE ONLY.
I
Filter 2
key pressed
OK
"*" in
Filter Nº
4. Problems and possible cause
Effect
There is no longer a
signal being delivered
to output.
J J
and the RESET
L
M
The channel configu-
ration programmed in
the SURF PRO is not
saved in the UCF 300.
Filters
Poor output quality in
all channels.
6
8 10 16 Low level "L" is
indicated on a filter
109 108 107 105
but the input signal
level is correct.
9
UCF 300
djacent to
Input
ttenuator ON
Adj02 U2AT
F01 CH24 30
Channel Gain
Possible cause
The programming
of a filter or the
configuration of UHF
inputs has been
changed.
The programmed
configuration has not
been memorised in
the SURF PRO.
Very high input level.
Excess output level.
Signals with high
levels on other filters
connected to the
same UHF input.
OK
ction
Charge the UX input
with 75 Omh and
re-adjust the output
level.
Carry out point 1.6
in the manual.
See input levels in
Main Characteristics,
page 2 of the manual.
See points 1.2 and
1.4 in the manual and
comply with the
values in Table 2.
Distribute the antenna
signal and connect
the filter to the UHF
input where high
level signals are not
processed.