Publicité
Les langues disponibles
Les langues disponibles
ENGLISH
3. Fill the tank: after add beans, then pouring the desired amount of water in the
tank from the indication on the inner cover (see fig.4), and the water level
shall according to the gauge located at the right of the tank.
Note: before filling water, the inner cover must be assembled in place.
4. Pull out the filter holder: Place itself permanent filter in the filter holder and
replace the filter cover. Then push the filter holder in place.
Note: a permanent filter may allow some ground coffee to flow into carafe.
5. Close the tank cover: Press down to lock. The appliance is equipped with a
safety interlock system. The details refer to the section of "PROBLEM
SOLVING".
6. Before brewing coffee: Make sure you have replaced the carafe in its
position on the keeping warm plate.
7. Plug the cord into an electrical outlet. "88：88" will display and flash on the
LED, after 5s, "12:00" will appear until you set the time. Set the current clock
according to the "Set the clock" section on the above.
8. Make sure the indicator of grind off must be extinguished.
Note: If the indicator of grind off is illuminated, it means that the appliance is on
the "make coffee with pre-ground bean" mode. The appliance will omit the step
of grinding bean.
9.Select Cups Setting: The 1-4cup setting button is used to control the time of
grinding bean, if you want make 1-4 cup coffee, press the button and the
indicator of 1-4 cup will be illuminated. The time of grinding bean is about 30s.
If you do not press the button, the default set is 5-12 cups. The time of
grinding bean is about 40s.
Note: the 1-4 cup button only use in the "make coffee with bean" mode. In other
words, the indicator above of the button of grind off must be extinguished. In
the "make coffee with pre-ground bean" mode, it is unused. And during
operation, the button is not activated.
Fig.4
Proportions
exaggerated
for clarity
Publicité
