Logitech Pure-Fi Elite Mode D'emploi page 7

Acoustic Features
The Pure-Fi Elite ™ system uses an advanced, high-fidelity acoustic design. The acoustic system uses:
• (2) 1" ventilated soft-dome tweeters
• (2) 4" reinforced high-power, long-throw, polypropylene woofers
Pure-Fi Elite ™ 's sound field can be adjusted to your personal listening preferences — using the bass,
treble and StereoXL adjustments described above.
11
English
620-000474 Pure-Fi Elite_MNL.indSec1:11-Sec1:12 Sec1:11-Sec1:12 620-000474 Pure-Fi Elite_MNL.indSec1:11-Sec1:12 Sec1:11-Sec1:12
All manuals and user guides at all-guides.com
Troubleshooting
My iPod is in the Dock and playing, but I can't hear any music.
• Make sure that Pure-Fi Elite ™ is on.
• Make sure that the iPod input is selected.
• Make sure that the volume level on Pure-Fi Elite
to adjust.
• Try turning off the Sound Check feature on your iPod.
• Download the latest version of iTunes (available at apple.com) and upgrade your iPod to the
latest iPod fi rmware.
• To test the iPod output, try with headphones.
There isn't a Universal Dock adapter for my iPod.
• If you have a newer iPod, a Universal Dock adapter for your iPod should have been included with your iPod
when you purchased it.
• If you have a 1st, 2nd, or 3rd generation iPod, you need to use the Aux input connector on the back of
Pure-Fi Elite ™ . (1st / 2nd generation iPod models do not have a dock connector. 3rd generation iPod models
are not supported by the Pure-Fi Elite 's Universal Dock.)
™
The AM radio reception is poor.
• Use the external AM antenna.
• Make sure to disconnect the wires for the internal AM antenna before connecting the external antenna.
The FM radio reception is poor.
• Use the external FM antenna.
• Make sure that the antenna is fully extended. Leaving the antenna coiled up will result in poor reception
Music played through the Aux input sounds distorted.
• Make sure the cable is completely plugged into Pure-Fi Elite
• Turn down the volume level on your source device.
The remote isn't working.
• Point the remote directly at Pure-Fi Elite .
™
• Make sure the remote sensor isn't being blocked. (It is located below the iPod.)
• Try using a fresh set of batteries.
is at least half way up. Use ( / ) on the speaker
™
and your source device.
™
12
English
11.2.2008 13:10 11.2.2008 13:10