Conrad 396453 Mode D'emploi page 26

All manuals and user guides at all-guides.com
•. Open the window and measure the width of the window. The window guide (10) can be used only with sliding
windows.
•. If the window is too wide for the window guide (10), you can obtain an additional window guide from your seller.
Obtain information from your seller.
•. If the window is too narrow for the window guide (10), remove the inner part of the window guide.
•. Shorten the inner part of the window guide (10) to the desired length.
•. Insert this into the outer part of the window guide (10) and extend the window guide to the required length on the
window.
•. If necessary, use screws to fasten the window guide additionally. Consult your specialist dealer.
•. After mounting the window guide to the window, tighten the nut of the screw/washer/nut combo (11).
•. The window guide (10) will be fastened when the window is closed.
•. Now guide the adapter (13) into the opening of the window guide (10) (Dia. C).
You can also hang the exhaust hose (12) out of the window without using the window guide (10). Close
the.window.as.much.as.possible.to.prevent.warm.air.from.flowing.back.in.
Dia. D
•. During the installation, the exhaust hose (12) should be placed as straight as possible (Dia. D). Do not extent it and
do not connect it to other exhaust hoses, which may cause malfunction.
•. Do not bend the exhaust hose (12) (Dia. E).
Attention! Place the product in an upright position and wait for approximately 2 hours prior to switching
the.device.on,.so.that.the.coolant.can.flow.into.the.necessary.lines.
26
Dia. E