Ingersoll Rand 359 Manuel D'instructions page 2

FAILURE TO OBSERVE THE FOLLOWING WARNINGS COULD RESULT IN INJURY.
WARNING
Always wear eye protection
when operating or perform-
ing maintenance on this tool.
WARNING
Air powered tools can vibrate
in use. Vibration, repetitive
motions or uncomfortable po-
sitions may be harmful to your
hands and arms. Stop using
any tool if discomfort, tingling
feeling or pain occurs. Seek
medical advice before resum-
ing use.
WARNING
Keep body stance balanced
and firm. Do not overreach
when operating this tool.
FAILURE TO OBSERVE THE FOLLOWING WARNINGS COULD RESULT IN INJURY.
•
These Sanders will operate at the free speed
specified on the nameplate if the air supply line
furnishes 90 psig (6.2 bar/620 kPa) air pressure at
the tool. Operation at higher air pressure will
result in excessive speed.
•
Use only a sanding pad, buffing wheel or polishing
bonnet with these tools. Do not use any grinding
LUBRICATION
Ingersoll–Rand No. 50
Always use an air line lubricator with this Sander.
Filter–Lubricator–Regulator Unit.
For International – C28–C4–FKG0
For USA – C28–04–FKG0–28
After each two hours of operation, if an air line
lubricator is not used, inject 0.5 to 1 cc of oil into (9).
After every 160 hours of operation, flush the tool with a
solution of three parts cleaning solvent to one part oil.
Model
359, 359–EU
H
Tested in accordance with ANSI S5.1–1971 sanding on steel workpiece
♦ Tested in accordance with ISO8662–1 sanding on steel workpiece
All manuals and user guides at all-guides.com
WARNING LABEL IDENTIFICATION
90 psig
(6.2bar/620 kPa)
SANDER SPECIFIC WARNINGS
PLACING TOOL IN SERVICE
Ingersoll–Rand No. 68
SPECIFICATIONS
Pad Size
in (mm)
3–2/3 x 9 (93 x 228)
WARNING
Always wear hearing
protection when operating
this tool.
WARNING
Do not carry the tool by the
hose.
WARNING
Operate at 90 psig (6.2 bar/
620 kPa) Maximum air pres-
sure.
wheel, bur or metal removing accessory other than
a sanding pad with these tools. Never use an
accessory having a maximum operating speed less
than the free speed of the Sander in which it is
being used.
MAIN LINES 3 TIMES
AIR TOOL INLET SIZE
TO
AIR
SYSTEM
TO
AIR
TOOL
LUBRICATOR
REGULATOR
BRANCH LINE 2 TIMES
AIR TOOL INLET SIZE
DRAIN REGULARLY
Free
Speed
rpm Pressure
8,000 78.4
2
WARNING
Always turn off the air sup-
ply and disconnect the air
supply hose before install-
ing, removing or adjusting
any accessory on this tool,
or before performing any
maintenance on this tool.
WARNING
Do not use damaged, frayed
or deteriorated air hoses
and fittings.
International Warning Label:
Order Part No. ___________
FILTER
COMPRESSOR
(Dwg. TPD905–1)
♦Vibrations
HSound Level
dB (A)
Power
–––
Level
2
m/s
9.2