Beamz Light Set 4-Some Clear Manuel D'instructions page 4

DISPLAY
The unit can be linked together in daisy chain as many as you need in master/slave mode to perform the great
built-in pre-programmed lighting shows triggered by music.
In Master/Slave mode refer to the DMX settings below:
Master unit : when working at Auto-run or Sound Control mode operation
Slave units : DMX start address MUST be set to d001.
DMX-512 CONNECTION
If you are using a standard DMX controller, you can connect the DMX output of the controller directly to the DMX input of the
first unit in a DMX chain. Always connect the output of one unit with the input of the next unit until all units are connected.
If you use a controller with 5 pin DMX connection you will need to use a 5-pin to 3-pin adapter.
At the last fixture, the DMX cable has to be terminated. Solder a 120 Ohm resistor between signal (-) and signal (+)
into a 3-pin XLR connector and plug this into the DMX output of the last fixture in the chain.
REPLACING THE FUSE
If the fuse is defective, replace the fuse with a fuse of the same type and value. Before replacing the fuse, unplug mains lead.
Procedure:
FIXTURE CLEANING
The cleaning of internal and external optical lenses and/or mirrors must be carried out periodically to optimize light
output. Cleaning frequency depends on the environment in which the fixture operates: damp, smoky or particularly
dirty surrounding can cause greater accumulation of dirt on the unit's optics.
 Make sure the area below the installation place is free from unwanted persons during servicing
 Housings, fixations and installations spots( ceiling, truss, suspensions) should be totally free from any
deformation
 The mains cables must be in impeccable condition and should be replaced immediately when even a small
problem is detected
 In order to protect the fixture from overheat the cooling fans (if any) and ventilation openings should be
cleaned monthly.
 The interior of the fixture should be cleaned annually using a vacuum cleaner or air-jet.
 Clean with soft cloth using normal glass cleaning fluid.
 Always dry the parts carefully.
 Clean the external optics at least every month. Clean the internal optics at least every 30/60 days.
ATTENTION: We strongly recommend internal cleaning to be carried out by qualified worker!
4
Three ways to operation:
A. Master/Slave operation
B. Easy sound active and Auto mode
C. Universal DMX controller
Step 1: Open the fuse holder on the rear panel with a fitting screwdriver.
Step 2: Remove the old fuse from the fuse holder.
Step 3: Install the new fuse in the fuse holder.
Step 4: Replace the fuse holder in the housing.