Publicité
Les langues disponibles
Les langues disponibles
First use
Connect the speaker with the Micro-USB cable and a USB power
adapter (not included in the delivery).
Press and hold the power button (9) for two seconds until the
activation sound appears. The working indicator LED turns blue.
Now the device is ready for pairing. Open the Bluetooth settings on
your Bluetooth device and select the „MusicMan BT-X50" from the
device list. You can also use the speaker with Aux-In or SD-card.
With the mode button (9) you can change the mode from Bluetooth
to AUX or SD-card.
How to charge the Neckband-Speaker BT-X50
The BT-X50 has an internal, rechargeable battery which must be fully
charged before used for the first time. It takes about 3 hours to charge
the battery full for the first time.
You can charge the speaker either by using a common USB adapter*
(5V/1A) (*not included). While charging the charging indicator LED
will turn RED. When the speaker is fully charged, the charging
indicator LED will turn off.
The fully charged battery of the speaker has power for up to 4 hours
of playing time or up to 27 hours of standby time. The batterie status
will be visible on your phone while connected with Bluetooth.
Mode
Bluetooth Mode
Pairing is the process of establishing a link between BT-X50 and
Bluetooth devices. If no pairing is made over 10 minutes, the speaker
will cancel the pairing mode and turns off.
The speaker must be powered on before you begin to initiate the
pairing.
Note: Activate the Bluetooth feature on the phone, and set the
phone to search for Bluetooth devices. Check the user guide of
your phone for instructions.
Select the speaker „MusicMan BT-X50" from the list of found
devices. When asked the PIN code, please enter "0000" to pair the
speaker to your phone.
If the pairing is successful, you will hear a connection sound and the
speaker enters idle state.
Publicité
