Setting-Up Operation; Using The Radio-Controlled Socket; Using The Remote-Control; Trouble-Shooting - SilverCrest 60494 Instructions D'utilisation Et Consignes De Sécurité

Setting-up operation

Q
Using the radio-controlled
Q
socket (fig. B)
1. Put the radio-controlled socket into
any shuttered socket and connect
the appliance you want to operate.
2. Switch the electrical appliance on.
The radio-controlled socket can
only perform its switching function
when the device to be controlled is
switched on.
A TTENTION! FIRE HAZARD!
Do not attach any appliances which
could cause fires or other damaged
if left unattended when switched
on. The maximum load of every
radio-controlled socket is approx.
3.600 W. Any overload could cause
a risk of fire or damage to the device.
3. Press the manual ON / OFF button
to switch the remote-controlled
5
socket on directly on the appliance.
The LED operating status display
will shine. Alternatively, you can also
switch the remote-controlled socket
on using the remote control (See
"Using the remote control").
4. Press the manual ON / OFF button
to switch the remote-controlled
5
socket off directly on the appliance.
The LED operating status display
will go out. Alternatively, you can
also switch the remote-controlled
socket off using the remote control
(See "Using the remote control").
Using the remote-
Q
control (fig. A)
1. Use the button ON / OFF
the channel whose device you would
like to switch on or off. The remote
control controls up to 4 radio-con-
trolled sockets (individually, in groups,
or all at the same time).
2. Use the ALL-ON / OFF button
switch all radio-controlled sockets on
or off at the same time.

Trouble-shooting

Q
If the remote control does not
work, please check the follow-
ing points:
Prob- The operating indica-
lem tor
control device illumi-
nates but there is no
6
reaction
Rem- · Check that the batteries
edy
6
Setting-up operation
2
on the remote
1
still have enough power.
If applicable put in new
batteries.
GB
for
to
3
25