Remington PG6070 Mode D'emploi page 7

ENGLISH
• To achieve the desired hair length, change the guide comb by easily sliding it
onto one of the three slots on the attachment head. The different slots
represent 3mm, 6mm and 9mm hair lengths.
• Place the flat top of the trimmer comb against the skin. Slowly slide the
trimmer through the hair, in the direction of hair growth.
• Use slow and well controlled movements.
• If hair bulds up in the guide comb during the trimming process, switch the
unit off and pull off the guide comb. Brush the trimmer and rinse the comb.
• Note: the wide trimmer can also be used to trim body hair. This wide trimmer
head contains the vacuum technology to conveniently collect trimmed hair
in the vacuum chamber.
• Regularly check the level of collected hair in the vacuum chamber. Once this
becomes full, switch off the beard trimmer and then remove the vacuum
chamber to empty the hair clippings. To continue using, slot the vacuum
chamber back into product and then slide on the power switch.
, Tips for best results
• Beard, moustache and sideburn hairs should be dry.
• Avoid using lotions before use.
• If you are trimming for the first time start with the maximum comb length
setting.
C CARE FOR YOUR BEARD TRIMMER:
• Your beard trimmer is fitted with high quality blades.
• To ensure long lasting performance of your clipper, clean the blades and unit
regularly.
, AFTER EACH USE
• Ensure the beard trimmer is switched off and disconnected from the mains
before cleaning.
• Brush the accumulated hair from the blades.
• To clean unit, wipe with a damp cloth and dry immediately.
• Do not submerge the clipper in water.
• Remove vacuum chamber from unit, empty chamber and rinse under
running tap.
, WASHABLE ATTACHMENT HEADS
• The washable attachment heads are designed to ensure easy maintenance of
your beard and grooming kit.
• Ensure each of the attachment heads are removed from the beard trimmer.
7