Publicité
Les langues disponibles
Les langues disponibles
ENGLISH
, VACUUM FEATURE
• The Vacuum technology captures virtually all the facial hair as it is cut. The
hairs are vacuumed into an easy empty vacuum chamber located on the front
of the beard trimmer. It is recommended that you empty the vacuum
chamber after each use by sliding out the section away from the beard
trimmer.(Fig. A)
C GETTING STARTED
, CHARGING YOUR APPLIANCE
• Ensure the product is switched off.
• Connect the charging adaptor to the product and then to the mains.
• Before using your beard and grooming kit for the first time, charge the unit for
4-6 hours for optimal performance. Typical charge time will be 4 hours
thereafter.
• When charging the LED charge indicator will turn blue. The blue light will turn
off after charging is complete.
• To preserve the life of your batteries, let them run out every 6 months then
recharge for 4 hours.
• This appliance should be charged by approved safety isolating adaptors
PA-0510E (for EU version) or PA-0510U (for UK version) with the output
capacity of 5.0V dc; 1A;
, CORDLESS USE
• Please note that this product is cordless use only and cannot be used when
connected to the mains.
• When the unit is switched on and fully charged, the product can be used in
cordless mode for up to 60 minutes.
, WARNING: Keep the appliance dry.
F INSTRUCTIONS FOR USE
, TO ATTACH / REMOVE ATTACHMENT HEADS
• Select attachment head that best fits your grooming needs.
• Place attachment head on top of the unit. Secure carefully until the
attachment head clicks into place.
• To remove attachment head press the head release buttons on the side of the
head and pull the attachment head away from the unit body.
• Slide On/Off Switch upward to power the beard trimmer.
4
Publicité
