Binatone HC-430 Manuel D'instructions page 8

All manuals and user guides at all-guides.com
12.Barber comb
13.Styling shears
14.Clipper oil
15.Cleaning brush
BEFORE USE
Before the first use or if you did not use the
device for more than 6 months, charge the bat-
tery for over 16-24 hours.
Check if the blades are well oiled and there is
no excess oil on their surfaces.
Use this appliance on wet hair or under
shower.
Sit the person you are going to give a hair cut to, in a position
that you can have a good look on the crown of his (her) head.
Cover his (her) neck and shoulders with a towel.
Before starting to cut make sure that the hair is well combed.
Remember the direction in which the hair grows and the shape
of the back of the head so you may take that into account
while cutting the hair.
To make the haircut uniform and even, move the clipper slowly
through the hair without forcing it.
When making your first haircut it is better leave the hair longer,
until you become familiar with each of the attachment combs.
Always begin with the attachment comb with the longest length:
you can always make the hair shorter afterwards.
INSTRUCTIONS FOR USE
Hair-cutting device charging
1. Connect the device power cord to the power
adapter (5).
2. Make sure the battery charging indicator (4)
light is continuously green.
Note: battery charging time is 8-10 hours.
Battery powered operation time is about 60 minutes.
The battery charging indicator can be switched on
with a time delay (several minutes). When the
adapter (5) is connected to the power grid, it can
become warm, this is completely normal.
Attachment installation
To install the sliding attachment (7 A/B), hold it so that the
tines are pointing upwards, and guide the plastic fixtures (8) of
the attachment with sliding movements along the grooves on the
device casing (9, Fig. 2). Then, pressing the tip fixing lever (10),
fix the attachment (7 A/B) in one of the 7 positions indicated on
the body (1) in the window (11) dependent on the desired hair-
8