Binatone HC-430 Manuel D'instructions page 11

All manuals and user guides at all-guides.com
Mid-sized hair-cut (Fig. 4)
For this hair-cut, install the attachment (7 A or B) to the posi-
tion from 1 to 7 dependent on the area being cut (Fig. 4a). This
hair-cut gives a flat surface to the back of the head.
The most important prerequisite for each hair-cut is to properly
dry hair before cutting. Dry the hair against the hair growth
direction to bristle the hair (Fig. 4b).
Start hair cutting from the back and sides (Fig. 4а) (ref. to the
Short hair-cut section).
To enable you to obtain a smooth finish, use the barber hair-
brush (12) or fingers (Fig. 4с). Remove the hair-cutting at-
tachments (7 ) from the device. Using the barber hairbrush
(12) or fingers, lift a small hair strand (hair should be in a
vertical position as compared to the head), move the hairbrush
(12) or fingers along the strand length until you get the de-
sired length. The height of the cut strand is the example for the
next one. Continue cutting strand-by-strand, moving from the
back towards the forehead. Regularly comb hair to remove
cut strands and check the hair-cut results.
For obtaining a smooth transition area (marked with a bold line
in Fig. 4а), located between the head back hair and the side
hair, slightly decline a flat hairbrush and cut-off the standing
hair (Fig. 4d).
Cut hair-cut contours and whiskers as shown in the
Short hair-cut section.
Long hair-cut
This kind of hair-cut with hair cut off at the sides and at the back
gives long front hair.
Cut the back and side hair following the procedure described
in the Short hair-cut section. Cut the hair only until the bold
line in Fig. 4а.
Starting with this level (located several centimeters above the
ear), use a flat hairbrush to obtain a smooth transition zone.
Decline the hairbrush against the head and cut off the stand-
ing hair using the hair-cutting device without any attachment
(7). In this case the hairbrush serves as a guide (Fig. 4d).
Do not cut hair from the top.
Cut hair-cut contours and whiskers as shown in the Short
hair-cut section.
Comb the hair as desired.
How to maintain the hair-cut
To maintain the hair-cut, from time to time trim the hair-cut
contours on the head back, whiskers and hair around the ears as
described in the Short hair-cut section. For this, no attachments
(7) is used.
Beard cutting
Start cutting the beard under the chin. Move the device sym-
metrically either to one side, or to the other (Fig.5).
Hair out of the beard contour should be cut with an upturned
device, with no tip attached. Cut hair in short careful moves.
11