Using Laundry Product Dispensers - Kenmore 110.2613 Série Guide D'utilisation Et D'entretien

Using Laundry Product Dispensers

NOTE: Do not add single-dose laundry packets, color-safe
bleach, or fabric softener crystals to dispensers� They will not
dispense correctly�
4.
Add HE detergent
HE removable
detergent tray
Add a measured amount of HE liquid
detergent into detergent tray� This tray holds
3 oz� (89 mL)� If adding powder HE detergent remove inside
tray. Do not overfill tray - adding too much detergent may
cause detergent to be dispensed into the washer too early�
NOTE: Make sure tray is in drawer when using liquid detergent
and removed when using powder detergent and do not go over
the Max line�
IMPORTANT: Use only High Efficiency detergents. The package
will be marked "HE" or "High Efficiency." Low-water washing
creates excessive sudsing with a regular non-HE detergent�
Using regular detergent will likely result in longer cycle
times and reduced rinsing performance� It may also result
in component failures and noticeable mold or mildew� HE
detergents are made to produce the right amount of suds for
the best performance� Follow the manufacturer's instructions to
determine the amount of detergent to use�
HELPFUL TIP: See "Washer Maintenance" for information
recommended method of cleaning washer dispenser trays�
5.
Add liquid chlorine bleach
to dispenser
Liquid
Chlorine Bleach
Do not overfill, dilute, or use more than 1 cup (236 mL).
Do not use color-safe bleach or Oxi products in the same
cycle with liquid chlorine bleach�
10
6.
Add liquid fabric softener
Fabric softener tray
Pour a measured amount of liquid fabric softener
into tray; always follow manufacturer's directions
for correct amount of fabric softener based on
your load size� Close dispenser drawer� Fabric
Softener is added during rinse�
IMPORTANT: Do not overfill or dilute. Overfilling dispenser
will cause fabric softener to immediately dispense into washer�
If Two Rinses option is selected, fabric softener will be
dispensed into the last rinse�
It is normal for a small amount of water to remain in the
dispenser at the end of a cycle�
7.
Touch POWER to turn on washer
Make sure the dispenser drawer is closed completely, then
touch POWER to turn on the washer� Other methods of
turning the washer on include opening the lid or turning
the cycle selection knob�