PRO-POINT 8353906 Mode D'emploi page 8

V 2.0
INSTALLING OR REMOVING BATTERY PACK
1. Always switch off the machine before insertion or removal of the battery pack.
2. To remove the battery pack, push the button on the battery pack and pull the tool unit from the battery pack in
the direction.
3. To insert the battery pack, align the tool unit slides with the battery pack sliding groove and push the tool unit
into place. The tool unit can be slide into battery pack in two directions.
4. Do not force the battery pack in sliding it into tool unit. If the battery pack does not slide in easily, it is not being
inserted correctly.
CHARGING THE BATTERY PACK
1. Plug the fast charger into the power source.
2. Slide the battery pack into the charger as the arrow direction shown
on the charger.
3. Push the battery pack into place and make sure the red light on the charger is
"ON". The battery pack is now starting the charging cycle.
4. After finish the charging cycle, the light will turn into green. The battery pack is now
ready for use.
5. Your new battery pack is not charged. You need to charge it before use.
6. If you try to charge a battery pack from a just-operated machine, sometimes the
charging light will not come on. If this occurs, let the battery pack cool for a while then re-insert it and try to
charge again.
7. When you charge a new battery pack or a battery pack which has not been used for a long period, it may not
accept a full charge. This is a normal condition and does not indicate a problem. You can recharge the battery
pack fully after discharging it completely a couple of times.
8. While charging the second battery, allow the charger to cool down for 15 mins. before starting the second
charging process.
9. Unplug the charger from the power source after finish the charge.
8
All manuals and user guides at all-guides.com
18V Cordless Drill
For technical questions call: 1-800-665-8685
8353906