PRO-POINT 8353906 Mode D'emploi page 12

V 2.0
REPLACING CARBON BRUSH
1. Replacement procedure is as follows:
• Use T10 size bit to loosen the back cover screws and remove back cover by hand. (Fig.19)
• Take out the carbon brush. (Fig.20)
• Put the new carbon brush and housing back cover into the hosing in proper order. Refer to picture for the
direction of installing the carbon brush. (Fig.21-22)
• Lock the housing back cover clockwise by using T10 size bit. (Fig.24)
Fig. 19
Fig. 20
CAUTION! Always be sure that the machine is switched off and is unplugged from the power outlet removed before
carrying out any work on the machine. To maintain product safety and reliability, repairs, maintenance or adjustment
should be carried out by Princess Auto LTD.
INSTALLING OR REMOVING HOOK
1. Installing Hook:
• Use Phillips or slotted bit size
bit and tighten in clockwise.
DISPOSING OF THE TOOL
If your tool has become damaged beyond repair, do not throw it out. Bring it to the appropriate recycling facility.
12
All manuals and user guides at all-guides.com
18V Cordless Drill
Fig. 21
2. Removing Hook:
• Use Phillips or slotted bit size
Fig. 22
bit to loosen the hook.
For technical questions call: 1-800-665-8685
8353906
Fig. 24