Reversible Door - Nordcap W Série Mode D'emploi

Reversible door.
The door can be changed from right-hinged to left-hinged and vice versa as follows:
1. Lay the appliance on its back and loosen
the upper hinge.
4. Carefully remove the covers on the
side of the plinth using a flat-headed
screwdriver.
7. When the lock pin has been loosened
completely, pull it up together with the
lock cylinder and refit on opposite side.
10. After reversing the door, it is important to check that the sealing strip provides a tight seal all the way round. If it does not, carefully heat
the strip all the way round using a hair dryer. Then ease the strip outwards slightly so that it forms a tight seal against the cabinet. Be
careful not to heat the strip so much that it melts!
2. Remove the upper hinge.
5. Pull up the hinge pin...
...and fit it on the opposite side.
8. Click the covers into place on the plinth
sides on the opposite side.
7
3. Rotate the glass door through 180° (on
FZ 295 W, pull the handle to loosen it
on the inside from beneath the sealing
strip).
6. Unscrew the lock pin using a flat-headed
screwdriver.
9. Fit the door onto the bottom pin, fit the
top hinge and tighten securely.
GB