Publicité
Les langues disponibles
Les langues disponibles
START UP
1. Connect TriTech airless hose to sprayer. Tighten securely.
2. Connect other end of the hose to gun.
3. Tighten securely.
4. Remove �p guard.
5. Check inlet strainer for clogs and debris.
6. Fill upper retainer with TriLube to prevent premature packing wear. Do this each �me you spray.
7. Plug power supply cord into a properly grounded electrical outlet.
8. Place siphon tube set in grounded metal container par�ally filled with flushing fluid. Use mineral
spirits to flush storage oil.
9. Turn pressure control to lowest pressure. Open the Prime/Spray Valve so the handle is poin�ng
down.
10. Turn power ON.
11. Increase pressure to start motor and allow fluid to circulate through prime tube for 15 seconds;
then turn pressure down.
12. Turn prime / spray valve to the spray posi�on or so the handle is horizontal. Take spray gun trigger
safety OFF.
13. Hold gun against grounded metal container. Trigger gun and increase fluid pressure to half way.
Flush 1 minute. Inspect for leaks. If a leak occurs follow the pressure relief procedure then �ghten
fi�ng were leak occurred. Do not a�empt to stop leaks with hand or rag! Repeat Start-up 1-5 again. If
no leaks, proceed.
14. Place siphon tube in paint pail.
15. Trigger gun again into metal container un�l paint appears. Move gun to paint pail and trigger for 20
seconds. Set the safety to ON posi�on. Assemble �p and guard. (See following sec�on).
TIP AND GUARD ASSEMBLY
1. Insert metal seal and "black bellow" seal assembly by placing seals on the end of T93R Contractor �p
and insert through guard. Line up seals by turning �p.
2. Insert Tip
3. Screw assembly onto gun. Tighten.
SPRAYING
1. Spray test pa�ern. Start with pressure turned to its lowest se�ng, then gradually increase pressure
un�l you achieve a consistent spray pa�ern without heavy edges. Use smaller �p size if pressure
adjustment cannot eliminate heavy edges.
2. Hold gun perpendicular 10-12 inches in of front surface. Spray back and forth overlapping by 30%.
To prevent heavy spots, start moving the gun before pulling the trigger. When spraying, a�er releasing
trigger con�nue to move gun.
7
Publicité
