Intex FastFill I637USB Manuel D'utilisation page 4

DEFLATION
1. Connect the USB cable to an appropriate external power adapter. See Fig (2 - 5).
2. Turn the control dial to the deflation mark (
Deflation
mark
3. With the air bed fully deflated begin rolling the air bed from the end opposite of the pump
towards the end where the pump is located. See Fig (9).
4. When all the air is removed from the air bed, turn the control dial back to the off mark
( ) closing the valve.
5. Disconnect the USB cable from the external power adapter, place it inside the cord
compartment and close the cover. Make sure the USB cable is free of twists, kinks or
knots.
IMPORTANT NOTE
Proper inflation of the air bed.
The ambient temperatures of air have an effect on the air bed internal pressure. At low
ambient temperature the air will contract within the air bed and the air bed will feel softer:
add air as necessary. At high ambient temperature the air within the air bed will expand
significantly and the air bed will become hard and may burst: release air to avoid damage
to the air bed or to soften the feel. Do not expose the air bed to extreme temperatures (hot
or cold). Stretching is a natural characteristic of new vinyl. During initial use, the air bed
may become soft and require additional inflation to maintain desired firmness. This is
normal for the first few days of use. Dimensions shown are approximate and will vary due
to the vinyl temperature and the air temperature.
In no event shall Intex, their authorized agents or employees be liable for damages
(such as pin holes) to the air bed caused by negligence, ordinary wear and tear,
abuse and carelessness, or external forces.
STORAGE INSTRUCTIONS
1. Deflate the air bed following the "DEFLATION" instructions.
2. Make sure the air bed is clean and dry.
3. Lay the air bed flat with the sleeping surface facing upwards and follow the folding steps
on Figs (10 - 14). Fold the air bed loosely and avoid sharp bends, corners and creases
which can damage the air bed.
FIG (10)
4. Place the air bed inside the storage bag (if included) or the original packaging and store
in a dry place.
SAVE THESE INSTRUCTIONS
(37IO) I637USB ELECTRIC PUMP ENGLISH 4.875" X 7.25" 04/19/2023
FIG (8)
FIG (11) FIG (12)
Page 4
). See Fig (8).
FIG (13)
37
IO
FIG (9)
FIG (14)