GreenWorks VUG403 Manuel D'opérateur page 8

EN
8.4.1 WALL-MOUNTED CHARGER BASE
8.4.1.1 INSTALL THE CHARGER
1. Get the location of the wall to attach the charger.
2. Drill two aligned holes on the wall, and knock the
two shrink tubes (1-2) into the holes.
3. Put 2 screws (1-1) into the shrink tubes to attach the
charger base (1) on the wall.
1-2
The charger base, shrink tubes and screws are
provided with the vacuum cleaner.
4. Align the ribs of the charger (2) to the ribs of the
charger base (1), then push the charger (2) into
place. When you here a click, the charger (2) is
installed.
English
1-1
NOTE
8.4.1.2 REMOVE THE CHARGER
1. Press the base release button (3), and remove the
charger from the charger base (1).
8.4.2 STAND CHARGER BASE
8.4.2.1 INSTALL THE CHARGER
1. Align the hole on the rod with the release button
on the bottom base, and insert the rod (4-1) to the
bottom base (4-2).
2. Connect the upper rod to the lower rod.
8