GreenWorks VUG403 Manuel D'opérateur page 13

8. Allow the brush roll and chamber to dry before you
storing or picking up debris.
10.3 CLEAN THE PIPE
NOTE
Turn off the machine before maintenance or
troubleshooting to reduce the risk of electric shock or
injury.
1. Press the release button (8) to disconnect the
extender and floor brush.
2. Empty the collection bin.
3. Remove the brush roll.
4. Check the pipes of the vac, brush and extender.
5. Pump the debris out or use the wire to clean the
pipes if pipes are blocked.
English
8
11 STORE THE MACHINE
Clean the machine before storage.
1. Remove the battery pack.
2. Let the motor cool.
3. Check that there are no loose or damaged
components. If it is necessary, replace the damaged
components, tighten screws and bolts, or speak to a
person of an approved service center.
4. Store the machine in a cool and dry location.
12 TROUBLESHOOTING
Problem Possible cause
The switch or
The machine
motor is defec-
doesn't work.
tive.
The filter has
damage.
The filter isn't in-
stalled.
Dust discharges
from exhaust.
The filter is not
functional.
The filter clogs.
The filter clogs.
Loss of suction
The collection
bin is full.
The environment
Static shock
is dry.
Errors
13
NOTE
Solution
Speak to service
center.
Replace the fil-
ter.
Properly reinstall
the filter.
Clean or replace
the filter.
Clean or replace
the filter.
Clean or replace
the filter.
Empty the col-
lection bin.
Add moisture to
air (if practical,
use a humidifi-
er).
EN