Troy-Bilt DXX Serie Manuel De L'opérateur page 19

Problem
Uneven cut
Mower will not self propel
High pullback effort
All manuals and user guides at all-guides.com
Cause
1. Dull blade.
1. Belt not installed properly.
2. Debris clogging drive operation.
3. Damaged or worn belt.
4. Drive control out of adjustment.
1. Pulling mower backwards before
transmission disengages.
Remedy
1. Sharpen or replace blade.
1. Check belt for proper pulley installation and
movement.
2. Stop engine, disconnect spark plug boot,
and clean out debris.
3. Inspect and replace belt.
4. Adjust drive control. (See Assembly & Set-up
section).
5. Push unit forward a few inches before pulling
back. (See Operation section).
1. Allow the unit to roll forward slightly without
the drive lever(s) engaged before pulling
backwards.
S 8 — t
ection roubleShooting
19