Adam Hall CAMEO FLAT PRO Manuel D'utilisation page 11

COLOUR MACROS
In this mode, one of the 5 basic colours of the projector or one of the 10
different mixed colours can be selected as a preset.
Press the MODE button until "MACRO" appears in the upper line of the
display. Now press ENTER and then select one of the 15 colour presets
using the UP and DOWN buttons. Confirm with ENTER.
MACRO 01 = red
MACRO 02 = green
MACRO 03 = blue
MACRO 04 = white
MACRO 05 = amber
MACRO 06 = yellow
MACRO 07 = cyan
MACRO 08 = lavender
COLOUR CHANGE
In the colour change mode (jumping mode), 13 different colours alternate
in rapid succession (red, green, blue, white, amber, yellow, cyan, lavender,
pink, light green, magenta, turquoise, orange). The speed of the program is
adjustable separately and a stroboscope effect can also be activated.
Press the MODE button until "JUMPING" appears in the upper line of the
display. Now, press ENTER until the cursor appears in the lower line of the
display, and then select the rate (SPEED) using the UP and DOWN buttons,
with the colours alternating from 00 to 99.
Confirm with ENTER. The indicator in the bottom line of the display
changes to "FLASH:xx". The cursor will appear in the bottom line at the
same time and you can activate the stroboscope effect using the UP and
DOWN buttons and adjust the flash frequency from 00 to 99 (FLASH:00 =
strobe deactivated, FLASH: 01 = approx. 1 Hz, FLASH: 99 = approx. 20 Hz).
Confirm with ENTER.
COLOUR CHANGE
Rate SPEED:00 - SPEED:99
STROBOSCOPE
Flash frequency FLASH:00 - FLASH:99
MACRO 09 = pink
MACRO 10 = light green
MACRO 11 = magenta
MACRO 12 = turquoise
MACRO 13 = orange
MACRO 14 = cool white
MACRO 15 = warm white
OPERATION:
11